Hard Disk Drive


Answered on Jan 19, You must start the installation by opening the front cover of your Copystar CS Laser Printer, and then pull the waste toner container towards you, in order to remove it from the machine. When printing completes, place the remaining originals back into the original tray and press “Start” to continue copying. Posted on May 31, Be the first to answer. Please assign your manual to a product:

Uploader: Kezil
Date Added: 6 March 2017
File Size: 33.49 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 24122
Price: Free* [*Free Regsitration Required]

Without its optional memory board, the Copystar CS has speeds reduced to 15 ppm for letter and 13 ppm for legal. OEM Products come with a manufacturer warranty only. The Copystar CS also has a standard sheet feeder which can support 13 to 32 lbs. The output speed improvement is optional, for example, which means that users copstar still need to spend more significantly over some copiers that have built in memory enhancements in copyystar.

You can contact the customer service.

After that, you must use the attached tape to seal the old waste vs container, and then slide the exhausted toner cartridge to the left side of the compartment. You could check the remaining toner of the installed cartridge at any time by performing the procedure included below. The Copystar CS supports paper sizes from 5. The optional memory board has a 16 MB RAM capacity, which also allows the Copystar CS to handle customized copy tasks with improved efficiency and consistency.


Answered on Jul 12, Posted on May 02, Be the first to answer.

copyshar Remove originals placed on the original tray and allow the copy job from the plate to complete when the “E72” error displays. This brings the capacity of the Copystar CS to a total of sheets, with a maximum capacity of sheets by adding an optional drawer with the same capacity as the first drawer.

OEM Copystar 2A182010 Cs-1505 Cs-1510 Cs-1810 Original Drum Unit

Also, the duplex capability is still at a manual capacity, which is the same with the Copystar CS Answered on Jan 06, Level 2 Expert Answers. The link is for the KM which is the same as the CS Please copysatr that the [Add Toner] indicator will be on, when a low toner level has been detected. Regular ink dries quickly, which is why cartridges for inkjet printers do not last long. Answered on Mar 10, Copy speed can reach up to 18 pages per minute ppm for letter paper types and approximately 15 ppm for legal ones.

The Copystar CS actually bears uncanny similar resemblance to the Copystar CS, which is known for its relatively small size for a copier machine. Copystar CS Review Overview: Please assign your manual to a product: This product comes with a 6 month Warranty against any defects including free replacement.


Toner Level Check 1. At this stage of the installation, you must slide the new toner cartridge to the right side of the compartment until it stops, and then install the new waste toner container by carefully pushing it into the slot.

To avoid it you dopystar clear the toner cartridge first.

20 Most Recent Copystar CS Copier Questions & Answers – Fixya

Copystar CS Copier 62 Questions. Please note that you should shake the new toner cartridge again, if the [Add Toner] indicator is still on. Answered on Jan 19, When printing completes, place the remaining originals back copystag the original tray and press “Start” to continue copying.

Remove originals remaining in the original table when the “E90” error displays, indicating that the memory is full.

Once the new toner cartridge is unpacked, you must shake it at least 20 times vertically and 20 times horizontally, and then insert the prepared new component into the printer. While the Copystar CS features speed improvements and network capabilities, some users might still find it a bit lacking when compared to other copiers in the market.