Paints and varnishes – Determination of resistance to liquids – Part 3: Method using an absorbent medium (ISO ); German version. Buy DIN EN ISO PAINTS AND VARNISHES – DETERMINATION OF RESISTANCE TO LIQUIDS – PART 3: METHOD USING AN ABSORBENT. DIN EN ISO Paints and varnishes – Determination of resistance to liquids – Part 3: Method using an absorbent medium (ISO ).
|Country:||Turks & Caicos Islands|
|Published (Last):||26 November 2009|
|PDF File Size:||2.35 Mb|
|ePub File Size:||12.91 Mb|
|Price:||Free* [*Free Regsitration Required]|
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing.
Saturate each of the two test liquids with the other immediately before use. General test methods v.
Examples of test liquids are given in Annex A. Legal notices Photo credits FAQ. Wave-scan plus, measurement acc.
Multi-impact testing ISO Method for the calibration of ISO surface profile comparators and for the determination of surface – Stylus instrument procedure ISO Purchase More information add kso basket.
ISO Handbook “Paints and varnishes” の収載規格一覧 | 調べ方案内 | 国立国会図書館
Discover also Certification, assessment, diagnosis Get a quote for certification of systems, products or services, and get certified. Assessment of degree of chalking by tape method ISO Assessment of degree of rusting ISO Ring-and-ball method ISO NOTE 1 If for technical reasons an increased total paint coat thickness is necessary, this must be agreed upon by the parties involved.
Visual changes to the paint surface are not permissible. National regulations should be followed. Color and gloss level are to be documented in the first-sample test report or development sample test report acc.
DIN EN ISO – October
Determination of tralopyril release rate by quantitation of its degradation product in the extract ISO Preparation and protection of steel substrates ISO Collection of data ISO NOTE 2 Rods are used to eliminate edge effects. Raw materials ISO General introduction and designation system ISOPaints and varnishes — Evaluation of degradation of coatings — Designation of quantity and size of defects, and of intensity of uniform changes in appearance — Part 2: Page 4 TL Assessment of the storage stability of thermosetting powders ISO Execution and supervision of paint work ISO The main changes are: Oscillation method ISO For Methods A and B, both sides should preferably be coated and the edges protected.
The vessel and the test liquid shall already be heated to the specified test temperature in a heating cabinet 4.
For dated references, only the edition cited applies. Visual method ISO Classification of environments ISO Rotating abrasive rubber wheel method ISO Adhesive residues after removal of the preservative film are not permitted.
First and second coat are of the same color Permissible first coats for all colors: General introduction and classification ISO Field wn for the titrimetric determination of water-soluble ferrous ions ISO Report the results of all determinations, including any repeat determinations. Field method for the conductometric determination of water-soluble salts ISO Colour measurement ISO Coal furnace slag ISO Determination of unsaponifiable matter content ISO